Recommended calibration frequency

Crosby Straightpoint

  This email address is being protected from spambots. You need JavaScript enabled to view it.

 UK: +44(0)2392 484491    USA: +1 918 834 4611

load cell calibration test machine

Calibration interval should not exceed 12 months.

The frequency of calibrations should be determined by the user of the load cell based on the following factors:

  1. Frequency of use
  2. Severity of service conditions
  3. Nature of loading
  4. Experience gain using other similar products in same application

Once these factors are established the user may then establish the calibration frequency:

  1. Normal use – calibration every 12 months
  2. Severe use – calibration monthly to quarterly
  3. Special service – as recommended after consultation with SP engineering team and user.

A written record of the most recent periodic inspection shall include the condition of the load cell.

These guidelines fall in-line with ASME and LOLER recommendations.

Please let us know your name.

Invalid Input

Invalid Input

Invalid Input

Please let us know your email address.

Your email does no match please enter again

Invalid Input

Invalid Input

Once you have sent this form it will instantly reach a Crosby SP representative directly, who will respond to your enquiry by email ASAP. Or if you would prefer a call back please let us know in the message.
Note: Gmail email addresses will not be accepted on this form.